New embryo cryo tube Manufacturers china, including handle, inner tube, elastic ferrule, carrier rod, sleeve, convex edge; one end of the handle is thin and the other end is thick; the thin end of the handle is connected to one end of the inner tube, and the other end of the inner tube is thick. One end is connected with one end of the carrier rod, and the outer layer of the inner tube is sleeved with an elastic ferrule; the protruding edge is set on the inner wall of the sleeve, and the sleeve is sleeved on the thin end of the handle. Made of elastic material, the elastic ferrule can pass through the rib and be stuck behind the rib with a little force. When the embryo is resuscitated, since the elastic ferrule is stuck behind the rib, it can effectively prevent the carrier rod and the inner tube from being damaged. The phenomenon of flying, also, just need a little force to take out the carrier rod and inner tube from the casing.
The above is a brief introduction to the relevant knowledge about the new embryo cryo tube Manufacturers china.